-Meissner Effect - BBC Visions of the future, The Quantum Revolution.

 

 

 

-QuantumLevitation


Suspending a superconducting disc above or below a set of permanent magnets. The magnetic field is locked inside the superconductor ; a phenomenon called 'Quantum Trapping'.


For more info visit:


http://www.quantumlevitation.com

 

 

 

-LENZ'S LAW LEVITATION DEMONSTRATION

 

Description:

A coil of #22 magnet wire (5.5 inches in diameter w/ 100 turns) is energized with 120 volts AC (60 Hz) as it rests upon a .50" thick aluminum plate. As a result the coil will levitate as dictated by Lenz's Law. Unfortunately this design uses a tremendous amount of current and is prone to rapid heating. Further experimentation regarding coil size, voltage, frequency, and materials may improve its operation.

 

 

 

-Biefeld-Brown effect tested with Bi-Polar Tesla Coil

 

Testing some of the properties of the Biefled-Brown effect. Change the voltage level by increasing the spark gap. Using plastic to interrupt the dielectric to adjust flight characteristics. Added one module. Flash occurs regardless of 12cm distance. Diodes and Capacitor are rated for 80 KV. High voltage probe only rated for 40KV. Readings are questionable because the flashing based on the thumb rule is 10KV per cm. So flashing over 10cm would be 100KV?? You do the math. Lookup the Bi-Polar coil in action. I used 8 spark gaps and flash over 50 cm. Music is used with permission from WingMakers.com, All Rights Reserved. Song: AA Chamber 8

 

 

 

-Induction heater levitation melting aluminum

 

This is a 3kw induction heater levitating and melting aluminum. A small cylindrical chunk is levitated with 2-2.5kw of input power. I transform it into a molten, glowing ball before releasing it to the ground. You can read about it at http://www.mindchallenger.com/inductionheater

 

 

 

-Levitación electrostática (Electrostatic levitation)

 

 

 

-Acoustic Levitation Chamber

 

Description:

 

This is an acoustic levitation chamber I designed and built in 1987 as a micro-gravity experiment for NASA related subject matter.


The 12 inch cubed plexiglas Helmholtz Resonant Cavity has 3 speakers attached to the cube by aluminium acoustic waveguides.


By applying a continuous resonant(600Hertz) sound wave, and by adjusting the amplitude and phase relationship amongst the 3 speakers; I was able to control levitation and movement in all 3 (x,y,z) axis of the ambient space.
This research was used to show the effects of micro-gravity conditions that exist in the space shuttle environment in orbit, but done here on Earth in a lab.
This is not "anti-gravity." So don't waste time arguing something pointless.

 

Write a comment

Comments: 0